Differences

This shows you the differences between two versions of the page.

--- eduardo:polycom:hdx [2009/06/22 23:38] – created eduardo
+++ eduardo:polycom:hdx [2024/02/23 08:20] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+====== HDX Endpoints ======
+===== Remote Control Channel ID =====
+You can configure the Channel ID so that the remote control affects only one Polycom HDX system, even if there are other systems in the same room
+**To configure the channel ID for a Polycom HDX system and remote control:**
+  - Go to **Admin Settings > General Settings > System Settings > Remote Control**.
+  - Set the **Channel ID**.
+  - While blocking the IR signal on the remote control, press and hold the {{:eduardo:polycom:down.png|}} **Option** button for 5 seconds
+  - Press {{:eduardo:polycom:down.png|}} once to **Set ID**.
+  - Press the right arrow to change the setting.
+  - Press {{:eduardo:polycom:up.png|}} or {{:eduardo:polycom:down.png|}} to select the channel ID that you configured on the system.
+  - Press {{:eduardo:polycom:right.png|}} to select the new setting.